LEXMARK COLOR JETPRINTER SERIES 7000 DRIVER

Preventive Maintenance 7. Check for 8 to 18 ohms between pins 1 and 2 on the motor cable. Press in both sides opposite the cover latches until they latch. Looking for a tech gift that’s not too expensive? El personal professional ha d’estar-ne assabentat i prendre les mesures convenients. Turn the printer on. To reassemble, place the cover over the tabs in the bottom cover and press down until the cover latches.

Uploader: Tonris
Date Added: 25 May 2013
File Size: 21.90 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 76476
Price: Free* [*Free Regsitration Required]

Miscellaneous Rack Mounting Kit.

Disconnect the power supply connector at the system board. Maintenance Station Intermittent nozzle failures can be caused by worn parts in the jetprimter station. Install printer covers when you are not working on the printer, and do not put unprotected ESD-sensitive parts on a table. If you find a shorted pin, replace the motor.

Lexmark Color Jetprinter – printer – color – ink-jet Overview – CNET

Remove the small feed roll shaft. Paper Feed Assembly 4: Be sure the small feed roll spring extensions [B] are In the grooves of the small feed roll arms. To enter the test: Perform the “Paper Feed Service Check” on page When reinstalling the encoder strip, make sure the ends of the strip are centered in their mounting notches and the strip does not bind in the encoder card on the carrier.

  DVD TS H493B DRIVER DOWNLOAD

Feed the folded end of the printhead cable through the opening in the carrier assembly and remove the cable. A Lexmark nao e responsavel pela utilizagao de outros componentes de substituigao.

Note the routing of the motor cable.

Mid Frame Assembly Removal 1. Remove the paper feed motor and check the shaft for binds. Best Cyber Monday deals at Staples: Disconnect one of the printhead cables and turn on the printer.

The wipers clean the printhead nozzles as the carrier leaves the maintenance station. If the thermal sensor is connected and a “Thermal Sensor Not Installed” message prints, replace the thermal sensor. Tablets by David Carnoy Dec 13, Pull the pick roll shaft out to the left and remove the pick roll shaft, hubs and envelope bucklers. Install the compound idler gear and retainer clip after the printer is installed in the base assembly.

Lexmark 7000 Color Jetprinter Ink Cartridges

Be sure the parallel connector snaps do not get trapped behind the cover. The test page contains the following: Spread the right side frame away from the manual insert tray until the pins in the insert tray clear the frame.

  COMO HACER UN RAILDRIVER DRIVER DOWNLOAD

Seires non e responsabile per I’utilizzo di parti di ricambio di altri produttori. Envelopes, transparencies, greeting cards, plain paper, iron-on transfers, index cards.

You can obtain additional copies of publications related to this product by calling 1- Other trademarks are the property of their respective owners. Repeat this procedure for the parallel cable and the encoder seriea. Spread the left and right side frames apart far enough to remove the small feed roll shaft assembly.

Lexmark Color Jetprinter Ink Cartridges –

Carrier Transport Assembly 7: When the Power Light begins to flash, the Error Log clear is complete. High voltage is present in the power supply as long as it is plugged into the wall outlet. Puede que las caracteristicas de seguridad de algunas piezas no sean siempre evidentes.