3COM 3C940 GB ETHERNET LAN DRIVER

If this seems reasonable, go to the driver files supplied by 3Com and issue a simple “make” I guess you’ve done all this already? Copyright C 3Com Corporation. Ok running redhat-9 kernel version 2. Using jumbo frames can greatly improve performance for certain tasks, such as file transfers and data streaming. I also tried the driver delivered with mandrake 9.

Uploader: Arashijas
Date Added: 26 July 2006
File Size: 19.92 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 88852
Price: Free* [*Free Regsitration Required]

Drivers For Free – Network Marvell Semiconductor 3com 3c Gigabit Lom Ethernet Adapter Drivers

Find More Posts by blizwar2. Thanks Last edited by candyman; at Following the directions, I then run make load that 3c90 insmod 3c Now what is the kernel source and how do I install it?

I haven’t checked other sites. The one thing SysKonnect haven’t done is post a changelog, so I eghernet see what they’ve done since 6. Then browse to the location of the new extracted drivers.

So I got it working, but i have the 3c9940 others are having The driver I got on the CD was somewhere around version 6. If you need to reset your password, click here. I also tried the driver delivered with mandrake 9. Last edited by liontooth; at The module wont get inserted at more than Mbps when it shouldve been at 1Gbps I have 2 tar’s one from asus site and one from asus cd-rom do I have to make this file and how?

  LINKSYS WIRELESS NETWORK ADAPTER WUSB300N DRIVER

Matthew Gadient October 1, The most recent version is 6. Couldn’t get the Network figured out until I hit this post for a smilar motherboard.

So what to use?

3Com 3C Gigabit LOM Ethernet Adapter – Software Patch

I guess this matters ethermet it’s a lot easier to use a driver that’s in the kernel. Leave a Comment Cancel reply You can use an alias and fake email. I have an Abit IS7-G and supposidly have the same onboard chip.

It worked…exactly the way you said including the bit about Windows Vista updating to the 3Com driver as soon as I could get to the update site. I am just beginning to test stuff, but I do not expect any problems.

I got the Serial ATA plus raid work with mandrake 9. The time now is You may need to reboot and then check dmesg for where the NIC was placed — did it go to eth0 or eth1 that depends on whether you have other NICs. Now here are the problems.

Here is how i inserted the module[[ insmod 3c Both ports can operate independently of each other and can be connected to separate networks. Niles March 12, It may give you a warning about the driver, but I simply ignored it, let it install, and the network came up and was good to go.

  COMPRO VIDEOMATE E900F DRIVER DOWNLOAD

I even looked through the drivers I had to find the right one and I don’t even see that brand in the drivers.

Introduction to Linux – A Hands on Guide This guide was created as an overview of the Linux Operating System, geared toward new users as an exploration tour and getting started guide, with exercises at the end of each chapter. Using the sk98lin module from stock Mandrake 9.

Windows Vista – what driver to use for the 3Com Gigabit LOM (3C940) network card

It doesn’t list the 3Com 3c card, and likely won’t work without some modifications, however minor. Appearently i never installed some kernal dev packages or something because the command it was looking for GCC didn’t exisit. Doesn’t that preclude the ability to copyright the drivers?